Rubber Ramp Installation
Q1
What type of silicone is recommended for ramp installation?
Our installers and production team typically use Selleys Wet Area silicone. However, any high-quality silicone designed for wet area applications should be suitable for this purpose.
Q2
What should I do if the ramp needs to be raised at one end or side?
Provided measurements are accurate, any required adjustment should be minimal (1–2 mm). Use suitable packers to level the ramp and secure them with screws or silicone. Ensure all raised gaps and edges are properly sealed to avoid creating water traps.
Q3
How do I join two ramp sections together?
Test-fit both sections and apply a bead of silicone to the joining surfaces. Secure by drilling screws at a 45° angle, approximately halfway through the ramp's height. Use galvanised or stainless steel screws at 300 mm intervals for optimal strength and a clean finish.
Q4
Can I cut a notch in the ramp to accommodate an obstacle?
Minor shaping may be done using a utility knife. For more precise or larger adjustments, a jigsaw may be used — but only by a skilled tradesperson. Always measure carefully and remove small sections incrementally to avoid overcutting.
Q5
Is it possible to flatten or adjust the angle of the ramp?
In special circumstances, a planer can be used to thin the ramp. This should only be carried out by an experienced professional, as improper technique may result in uneven surfaces or compromised load-bearing capacity. Our rubber ramp products are not specifically designed for planing or reshaping.
Custom Shower Base Installation
Q1
How do I prepare the shower floor before installing the custom base?
Ensure the floor is clean, dry, and level before installation. Remove any debris, old adhesive, or loose tiles. Use a spirit level to check for high or low spots — the floor must be flat to within ±2 mm across its full length. Any significant dips should be filled with a suitable floor levelling compound and allowed to cure fully before proceeding.
Q2
What adhesive should be used to secure the shower base?
We recommend using a flexible tile adhesive or Selleys Wet Area silicone around the perimeter to bond the base to the floor. For rubber shower bases, do not use solvent-based adhesives as they may degrade the rubber compound over time. Apply adhesive evenly and allow adequate open time before positioning the base.
Q3
How should the drain be aligned during shower base installation?
The drain outlet in the shower base must align precisely with your existing floor drain or waste pipe. Mark the drain centre point on the floor before laying the base. If a cut-out is required, use a hole saw or jigsaw with the correct diameter. Always dry-fit the base first to verify alignment before applying any adhesive. Seal the drain connection with plumber's silicone to prevent leaks.
Q4
How do I seal the edges of the shower base to walls and tiles?
Apply a continuous bead of Selleys Wet Area silicone along all edges where the base meets the wall or tiles. Do not use grout in this junction — it will crack due to movement. For a clean finish, use masking tape on both sides of the join before applying silicone, then smooth with a wet finger and remove tape while still wet. Allow a full 24 hours cure time before use.
Q5
Can the custom shower base be cut to fit a non-standard space?
Yes — our rubber shower bases can be trimmed to fit non-standard or irregular spaces using a sharp utility knife or jigsaw. Always measure twice and cut incrementally. When trimming edges, ensure the cut remains straight and clean to maintain a proper seal against walls. Note that cutting beyond the specified tolerance may affect the product's structural warranty.
âš Disclaimer
Any physical modifications to the product — including cutting, reshaping, or structural alterations — should be undertaken with care and at the owner's discretion. Ezy Access Solutions does not accept responsibility for performance issues or product failure resulting from unauthorised alterations. Always consult a licensed tradesperson for plumbing connections.
